![]() ![]() However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Notice: The FCC regulations provide that changes or modifications not expressly approved by Shure Incorporated could void your authority to operate this equipment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer's instruction manual, may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Check USB hub documentation for current/port specification. MV5 is plugged in, but the volume meter does not register a signal.Įdit the privacy setting for the iOS device under SETTINGS > PRIVACY > MICROPHONE to give the recording application permission to use the microphone. Make sure that the sample rate and bit depth microphone settings, found in the sound control panel of the computer, are consistent with the sample rate and bit depth selected in your software. If level is reaching the red peak indicator of the input meter, turn the gain down. Use the audio meter to ensure that volume peaks are within the target range. When first connecting the MV5 to your computer, make sure to raise the computer volume level.Ĭheck the sound control panel of the computer to ensure that the MV5 is fully plugged in and recognized. Make sure that the MV5 is fully plugged in.Ĭheck the computer sound control panel settings. See your software user guide for information on assigning input sources. In your recording application, select the MV5 as the input source. ![]() Refer to the "Adjusting Microphone Level" topic in this guide for details. However, the modes typically do not require additional gain adjustments. If the audio is too quiet or causes distortion, gain can be manually configured. Use the MODE button to select the preset mode that fits your application.Note: When the MV5 is assigned as the audio device, all monitoring and playback from the recording software goes to the headphone output of the MV5. If you can hear sound, the microphone is functioning properly. To quickly verify that the device is recognized, plug headphones into the MV5 audio output and play an audio track. If your computer settings default to another device, open the sound control panel and select the MV5. Most computers and mobile devices automatically detect the MV5 and assign it as the primary audio device. Confirm that the MV5 is the selected audio device.Note: When using apps like Voice Memo, the LED will not light until Record is engaged. The Green status LED indicates a successful connection. ![]() Use the appropriate cable (USB or Lightning).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |